Electra-Gear 1 1/2 HP Stainless Electric Motor
The Leeson/EG 1 1/2 HP Stainless Steel Boat Lift Motor is a dual voltage, standard duty single-phase electric motor with a start capacitor. Fits normal gear plate mounting holes. Works with all BH-USA boat hoists and boat lifts. Also works with various other standard-sized flat-plate hoists. Includes aluminum end bells. Double-shielded ball bearings. Dynamically balanced rotors. 5/8 in. motor shaft.
NEMA 56 frame motor. UL listed and CSA approved. Features a totally enclosed, non-venting housing (TENV). The TENV housing helps prevent dirt and insects from getting into the electric motor. Maximum run time of 15 minutes. Easy-to-follow wiring diagrams included with the Leeson/EG 1 1/2 HP Stainless Steel Boat Lift Motor. Features colored T-wires. Includes cross-reference wire chart for all Leeson Electra-gear motors.
Does not work on direct-drive boat hoists or boat lifts.
Factory Electric Motors
Wired 220v from the factory (motor only). Allows for rewiring to 110v. Does not include an in-line GFCI, control cable, or drum switch.
BH-USA recommends using a licensed electrician to wire or rewire any electrical components.
It is a general-purpose motor most commonly used with a flat-plate hoist. The clawfoot mounting slots help install on a flat-plate hoist. Installing a belt and pulley onto the drive shaft allows the motor to turn the pulley. This will move the belt.
|Max Run Time:||15 Minutes|
|Dimensions:||9 in. x 10 in. x 6 1/2 in.|
|Horsepower:||1 1/2 HP
|Voltage:||115 / 230|
|Amps:||13.8 (110v) / 6.9 (220v)|
|SFtartA:||15.2 (110v) / 7.6 (220v)|
|Shaft Diameter||5/8 in.|
- Clawfoot mounting design
- NEMA 56 frame electric motor
- UL Listed & CSA approved
- TENV - totally enclosed, non-venting
- Standard duty, dual voltage
- Single-phase motor with a start capacitor
- Stainless steel finish w/ matte aluminum end bells
- 15 min. maximum run time