Electra-Gear 1 HP Stainless Electric Motor
Electra-Gear’s 1 HP Painted Electric Motor is a single-phase, dual voltage motor with a start capacitor. The motor is factory-wired to run at 220 volts. A licensed electrician can rewire the motor to run at 110 volts. Compatible with all BH-USA flat-plate hoists and gear plates. Fits other brands that use the standard 4 ft x 2 ft flat-plate mounting holes.
The motor is a NEMA 56-frame motor. UL/CSA listed and approved. TENV (totally enclosed, non-ventilating) housing. The TENV housing serves as a barrier against dirt, insects, and water entering the motor.
This motor has a maximum runtime of 15 minutes. Finished in black. Includes colored T-wires. The electric motor comes with easy-to-follow instructions. Included are BH-USA’s equipment guide and wiring instructions.
Clawfoot Motors
A clawfoot motor is a general-purpose motor. At BH-USA, these are used with flat-plate hoists. With clawfoot mounting slots, a standard flat-plate hoist can be easily mounted. By attaching a belt and pulley to the drive shaft, the motor can rotate the pulley. The belt will move as a result.
Specifications
Model #: | C6C17NK31 A |
Max Run Time: | 15 Minutes |
Dimensions: | 9 in. x 6 1/4Â in. x 9 1/2 in. |
Weight: | 32 lbs. |
Horsepower: | 1 HP |
Mounting Type: | 56 |
RPM: | 1725 |
Service Factor: | 1.15 |
Voltage: | 115 / 230 |
Phase: | 1/60 |
Amps: | 13.8 (110v) / 6.9 (220v) |
SFtartA: | 17.5(110v) / 8.25 (220v) |
Herz: | 60 |
AMB: | 40°c |
Frame: | 56 |
HSG: | TENV |
Code: | K |
Insulation: | F |
Shaft Diameter | 5/8 in. |
Product Overview
- Clawfoot mounting design
- NEMA 56 frame electric motor
- UL Listed & CSA approved
- TENV - totally enclosed, non-venting
- Standard duty, dual voltage
- Single-phase motor with a start capacitor
- Stainless steel finish w/ matte aluminum end bells
- 15 min. maximum run time