Locoloc #3-K Hydraulic Swager Kit
The Locoloc #3-K Hydraulic Swager Kit exerts 14 tons of pressure. A few strokes of handle brings the dies from wide open to contact with the fitting to be swaged. Then an internal valve automatically shifts from the low-pressure pump stage to the high-pressure compression stage. A relief valve prevents over-compression.
The advanced-retract control for the ram is located in the moveable handle. It is operated by twisting the handle less than a 1/4 turn.
Full visibility of the working area is afforded by the narrow, 180-degree swivel “C” head, making it easy to position the dies on the fitting. Gauge supplied with each die.
Very rugged, yet portable, this hydraulic hand swaging press with interchangeable dies is for compressing aluminum or copper oval sleeves on 1/4 in., 9/32 in., 5/16 in., 3/8 in., 7/16 in., and 1/2 in. diameter cable and wire rope, plus aluminum or copper stop sleeves on 1/4 in., 9/32 in., 5/16 in., and 3/8 in. diameter cable and wire rope.
1 #3-H Hydraulic Handswager Tool
6 Sets of Dies
6 Sets of Gauges
1 Carrying Case
ALWAYS USE GAUGE TO CHECK THE AFTER-SWAGE DIMENSION
The information below for Flexible Cable 7×19 / 6×19 Construction.
For Maximum Safety and Holding Power we recommend using Two (2) sleeves on 3/8 in. and larger.
- Exerts 14 tons of pressure
- Gauge supplied with each die
- Less than 1/4 Turn to Operate
- Compresses aluminum or copper oval sleeves
- Compresses aluminum or copper stop sleeves