Flat-Plate to A-Drive Hoist Hanger Upgrade Kit
The Flat-Plate to A-Drive Hoist Hanger Upgrade Kit is recommended for center mounting on wood beams. The drive pipe slides over the hoist sleeve and bolts into the driveshaft. Additional drilling into the drive pipe may be required.
The hoist hanger mounts to a wood beam or wood joist with (2) 1/2 in. mounting holes on the square end of the hanger plate. Used for upgrading your hoist from a flat-plate boat hoist to a direct-drive boat hoist. It follows the same mounting hole pattern as a flat-plate boat hoist.
Made out of steel. Laser-cut mounting holes. Two coatings, hot-dipped galvanized or powder-coated silver. The hanger plate follows industry-standard flange mounting guidelines. Allows easy adjustment to drive pipe supports already mounted.
Kit Includes:
(1) A-drive hoist hanger plate
(1) A-drive 40:75 driveshaft (depending on ID size)
(4) 1/2 in. x 1 1/2 in. hex head bolts
(8) 1/2 in. stainless steel flat washers
(4) 1/2 in. lock washers
(4) 1/2 in. stainless steel nuts
Installation:
When installed at the industry-standard vertical mounting, the mounting holes line up where the flat-plate boat hoist use to be. Horizontally mounting will require drilling extra holes in the wood beams to accommodate.
| Hoist Capacity |
A-Drive Direct Drive Gearbox |
Boat Lift Motor |
| 3,000 lbs. |
40:75 Double Worm Reducer |
Elite 3/4 HP Stainless Steel C-Face Motor |
| 4,000 lbs. |
40:75 Double Worm Reducer |
Elite 1 HP Painted C-Face Motor |
| 4,000 lbs. |
40:75 Double Worm Reducer |
Elite 1 HP Stainless Steel C-Face Motor |
| 7,000 lbs. |
40:90 Double Worm Reducer |
Elite 1 1/2 HP Stainless Steel C-Face Motor |
