2 in. Zinc Die-Cast Motor Pulley

The 2 in. Zinc Die-Cast Motor Pulley installs onto the driveshaft of an electric motor. The pulley is made from die-cast zinc. This means the pulley is lightweight and non-toxic. The pulley is produced with non-corrosive materials. It is used for fractional horsepower applications. The pulley features a 0.630 bore. It accepts up to a 50 inch drive belt. The pulley includes a 5/16 inch (18 thread) x 1/2 inch set screw. A key stock is used on the drive shaft of the motor then the set screw is tightened to the key stock to hold the pulley in place.

BH-USA uses the motor pulley with its electric wired motors with base. The motor is then installed onto a flat-plate gear plate. The motor pulley and the gear plate pulley is connected with a drive belt. This pulley fits all BH-USA gear plates and flat-plate boat hoists.